I didn't try to turn them before removal. I've done enough of these saws at this point to know that you will not have enough room within the factory limitations to correctly tune them, so we remove the stops on the limiter caps before firing them up.
The idle was so lean it would barely stay running, but the "H" speed didn't appear that far off. This was not the final testing, as it was too icy to put it in a log and see if it needs further tuning on the "H" speed screw under full load.....more to come....Cliff
The idle was so lean it would barely stay running, but the "H" speed didn't appear that far off. This was not the final testing, as it was too icy to put it in a log and see if it needs further tuning on the "H" speed screw under full load.....more to come....Cliff