Here's some photos of Farmertec MS200T parts (pre-Huztl Kit) from July 2018. Did not have any luck with the two carbs I bought, but the metal cast & machining seems decent enough.
This build was an experiment to run the Farmertec parts till it implodes. Tried to use everything as received without modification or OEM replacement where possible, even used the Farmertec spark plug. There was no Huztl kit at that point, so a few parts like the carburetor connector, oiler connector and some AV screws and springs had to be OEM; carburetor refused to idle, so ended up with used rebuilt of OEM carb. But engine and other moving parts are Farmertec (90%). Failure to date after running almost 30 tanks are: Carburetor, Intake boot, Oil pump.
The problem with Farmertec is that the products are inconsistent. For example, the oil-vent line that came with the tank assembly was very nice, but when I ordered a stand alone piece, it was too long and kinks when you install it.
Crank & Piston (after 20 plus tanks)
View attachment 680239 View attachment 680241
Cylinder - stock with no mods (after 20 plus tanks)
View attachment 680230 View attachment 680232 View attachment 680233 View attachment 680234
Crankcase and Cylinder (initial assembly)
View attachment 680235 View attachment 680236 View attachment 680242 View attachment 680238