Gumnuts
ArboristSite Guru
now thats indecent- must have been a type error
Finished up the 2nd 084 build
- Thread starter blsnelling
- Start date
Help Support Arborist Forum:
now thats indecent- must have been a type error
Lakeside53
Stihl Wrenching
I won't drink the stuff.. but I'll give it way...
Neener neener neener...
Here it is at rest.....
Here it is at rest.....
excess650
Addicted to ArboristSite
parts
where are you finding all your parts? i have an 084 and trying to rebuild but cant seem to find some of the important parts. dont want to pay dealer cost if i can help it. being that you have built three can i contact you with any questions in the future?
where are you finding all your parts? i have an 084 and trying to rebuild but cant seem to find some of the important parts. dont want to pay dealer cost if i can help it. being that you have built three can i contact you with any questions in the future?
Dealer and eBay. The dealer loved me when I built my NOS one
treebreeginning
ArboristSite Lurker
nice saws
i got a 084 also its a older one too wondering where i could order cheap bar and chains, well i kno their not cheap bu maybe something used
i got a 084 also its a older one too wondering where i could order cheap bar and chains, well i kno their not cheap bu maybe something used
harrygrey382
Addicted to ArboristSite
used - ebay
cheap new/used (but not crap) - Bailey's or Madsens
Hey, that saw looks familiar!
It should. Man, it is a brute. Nice looking saw, too. The plastic is all intact. Enormous compression, too. I would check it, but I don't know if I can pull it over without the release......
Brad,
When you sanded the plastic did you use 320 grit then clear??? Buff then clear? I was wondering how a wet sand then rubbing compound last buff would turn out. That clear sure makes the plastic snap!
When you sanded the plastic did you use 320 grit then clear??? Buff then clear? I was wondering how a wet sand then rubbing compound last buff would turn out. That clear sure makes the plastic snap!
I let each coat tack then sprayed another. I did nothing after spraying a few coats of clear.
This is the 084 I will be working with. Hopefully it'll turn out just as nice.
Nice saw. Looks pretty good already. I doubt I'd clear that plastic. I reserve that for plastic that's all faded out.
mines on its way so you can do your magic on it
how much does it take to get one on your door step,
i alsmost fel bad, i got both those saws for less than what 36" bar cost amd the 084 runs pretty good
is that a spare tube under your filter covers incase your truck gets a flat. or is mine misn that thing
how much does it take to get one on your door step,
i alsmost fel bad, i got both those saws for less than what 36" bar cost amd the 084 runs pretty good
is that a spare tube under your filter covers incase your truck gets a flat. or is mine misn that thing
Last edited:
It is?
The only one I have here is the one I built from NOS parts. The others were rebuilt and sold. I still haven't had a chance to mess with those 046/460s and probably won't this week
