Hey all, I recently purchased a Ms 462c , The saw is brand new and has never been used but it is almost 3 years old. The guy I bought it from never used it. I got a good deal on it so I took a chance. When I first tried starting it in the choke position it was flooding really bad, to the point where gas oil mixture was coming out of the seam of the front muffler cover. I pulled the muffler and spark plug to let it air out, put everything back together and I can get it to start cold as long as I don't choke it. It will run long enough for me to start tapping the throttle and let it run at higher rpms. It will run at just about any RPM but idle. I tried doing the mtronic reset but unfortunately I cannot get the saw to start in the choke position to let it idle for 30 seconds like you are supposed to do for a reset. I did put a little bit of seafoam in the gas since my mixture was 40 to 1 and since doing that I am able to get it started. Don't know much about these mtronic saws so I'm at a loss of what to do now. Dealer told me that I probably need to change the carburetor being that it is almost 3 years old. Carb literally looks brand new but it is 3 years old and not sure if the dealer put gas in it to start it when the previous owner bought it but the inside of the gas tank was spotless. Just wondering if there is anything else I can do before changing the carburetor?