Husqvarna 350 clutch

[DadJack]

Hi guys new to the site .
After a bit of help if possible from someone kind enough to share bit of advice ...
bought husky 350 and replaced chain tensioner and clutch bearing , replaced clutch back as was in correct position everything as should be , I’ve tightened clutch hand tight (anti) gave it a little clout to nip up . Started saw checked clutch is acting as should all seems fine then out of nowhere on 2 accessions clutch flys off ... what is it I’m missing , nothing I can fathom is wrong and clutch should tighten when starts surely ???

 

[stevetheboatguy]

I think most people have learned that one the hard way. You can't run a outboard clutch like that without the cover in place if you had it apart for any reason. They don't get fully tight until they have been used to cut a good bit of wood.


Steven