I did some trading and took this saw in earlier this week. The cylinder/piston are in good shape and I installed new rings while I had it apart. Everything on the bottom end looked good and the crank felt tight. Base gasket was deleted and squish is .028 no other mods where done to this saw.
Saw will need a air filter cover and a air filter clamp. The top cover bolts have been tapped but they seem to be holding tight. The clutch cover has a crack in the bottom of it and the muffler is dented.
I will take offers or trades
Saw will need a air filter cover and a air filter clamp. The top cover bolts have been tapped but they seem to be holding tight. The clutch cover has a crack in the bottom of it and the muffler is dented.
I will take offers or trades
