Tommy Brown
New Member
I bought a Jonsered 6000 bandsaw mill a while back. I had used it some until the motor Cylinder (Jonsered 2095) got all scratched up (I attribute it to crappy fuel my neighbor put in it.)
I rebuilt it and started it . it ran great for a few minutes then quit. I notice gas dripping from the motor at the carb/intake area (though I can't exactly see where the leak is).
I removed the air cleaner and the intake horn was loaded up with gas and still dripping, so I disconnected the fuel line to get it to stop. the fuel tank is above the level of the carb.
does anyone know what might be going on with this motor?
thanks.
I rebuilt it and started it . it ran great for a few minutes then quit. I notice gas dripping from the motor at the carb/intake area (though I can't exactly see where the leak is).
I removed the air cleaner and the intake horn was loaded up with gas and still dripping, so I disconnected the fuel line to get it to stop. the fuel tank is above the level of the carb.
does anyone know what might be going on with this motor?
thanks.