Sawyer Rob
Addicted to ArboristSite
Many years ago i use to make a lot of small "deer" to sell and give away as gifts. I thought it would be fun to make one again and show you how i do that with pictures...
I decided to make it out of a white pine i harvested some time ago...
I sawed this pine into 3x8's...
Because i damaged one of them when moving the pile, i set it aside to use for ??? Anyway, it's air dried now, so i cut a piece of it off, and ran it through my planer...
Once it was planed on both sides, i put it on the jointer and straightened one edge...
With one edge straightened, it went on the table saw, and i sawed off the end to get it nice and square...
Then i sawed off the length of piece i needed...
and then ripped it to the width i needed too...
I decided to make it out of a white pine i harvested some time ago...
I sawed this pine into 3x8's...
Because i damaged one of them when moving the pile, i set it aside to use for ??? Anyway, it's air dried now, so i cut a piece of it off, and ran it through my planer...
Once it was planed on both sides, i put it on the jointer and straightened one edge...
With one edge straightened, it went on the table saw, and i sawed off the end to get it nice and square...
Then i sawed off the length of piece i needed...
and then ripped it to the width i needed too...