Making progress on my motor!

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

NYH1

Tacticle Chainsaw Operator.
Joined
Oct 1, 2006
Messages
1,378
Reaction score
543
Location
Central New Yorkistan
As some of you guys know, I'm building a mild 385 stroker motor, 4.040" bore x 3.750" stroke. Some of you guys have been a BIG help. So thank you to everyone for all of your help.

Last week I clearanced my block so I had enough clearance between my rods and the block. Before I did any grinding at all, I could completely rotate the crank with all the rods and pistons moched up. I had no interference at all. However I didn't have the required .060" clearance between the block and a few of the rods. I only had to grind a little bit off the block down by the cylinders (#2, #4, #6 and #8). My crank and rods didn't come close to the oil pan rail at all. There was a ton of clearance there. I'm using a Scat rotating assembly. The crank is pt# 9-350-3750-6000 and the rods are pt# 2-ICR6000 (6 inch rods).

Today my cam and timing chain set came from Summit. The cam is a Lunati Voodoo 262/268 hydraulic flat tappet cam. Spec's are 219/227 dur. .050", .468/.489, LSA 112°. I moched the block up with the crank, rods and pistons along with the cam and timing chain and gears to check the rod/cam clearances. I didn't degree the cam in. I'll do that upon final assembly. I just installed it at zero on the timing gears. I installed one piston/rod set up at a time and checked the clearance between each rod and the cam lobes. I had more then enough clearance. Way more then the required .050". The rods didn't even come close to any of the cam lobes. I was surprised. The rods are stroker rods with cap screw bolts, but I was expecting to have to grind a little off of a few of the rods.

I checked my deck height on every cylinder today too. I checked them at each side of the piston in the same direction as the wrist pin go's to minimize piston rocking, which I didn't eliminate completely. The deck heights were .008" to .012". Again, I had a little piston rocking.

Next I have to file fit a complete cylinder worth of rings, top, middle and oil rings so I can get the rotating assembly balanced. I'm also going to take the cam bearings out so I can completely clean the block again.
 
I measured my pistons yesterday at room temperature (70°). They measured 4.036" ± .0002". The smallest one was 4.0358" and the largest was 4.0362".

My father and I measured the cylinder bores tonight. He set the temperature in the garage at 68° this morning before he went to work so everything would warm up by the time he got out of work tonight. They measured 4.040" ± .0003". The smallest was 4.0397" and the largest was 4.0403". I'm putting the smallest piston in the smallest cylinder and the largest piston in the largest cylinder. That gives me a piston to wall clearance of .004" ± .0001".

Keith Black's recommended piston to wall clearances for their FHR forged pistons as follows-
Street Normally Aspirated .0025" to .0035"
Street Towing .003" to .004"
Street Nitrous or Super Charged .0035" to .0045"

I'm glad my clearances are .004". Now I can put a 75 or 100 horse hitter on it down the road. I'll file fit the ring end gaps for this as well.

So far so good! :)
 

Latest posts

Back
Top