Mastermind Meets The Dolmar PS-6100

[TK]

How does one have a counterclockwise?

 

[Mastermind]

I got a CCW for you bud.

 

[fastLeo151]

I got a CCW for you bud.

How's muh fave monkey buddy doing today?

 

[Mastermind]

I'm good.

Fixin to dive back in on this Dolmar.

 

[fordf150]

opcorn:

 

[Mastermind]

I'm sorta slow......but I do real crappy work.

 

[Duane(Pa)]

I'm sorta slow......but I do real crappy work.

The beatings will continue until morale improves.....

 

[fastLeo151]

I'm sorta slow......but I do real crappy work.

I know you would rather be porting my purty 064

 

[fordf150]

I know you would rather be porting my purty 064

Your nuts! leave that saw alone

 

[Mastermind]

Andy is right......I'd rather do a MS660/066/064 than any other saw.

I just finished a MS650 that went from boring to bad MFer....

 

[Mastermind]

Pics?

Stock compression.



I used to cut squish by hand.....I had to use that method here.



Just taking out the lip around the out side in order to tighten the squish up a bit.





Now to take a little off the base.

 

[Mastermind]

Grindin.....

Rough in.







Finished.

 

[Mastermind]

After port work and machining.

Squish: .019
Ex: 105
Tr: 124
In: 77

 

[7sleeper]

I wanted to wright something sensible but at the moment....

7

 

[wcorey]

Just taking out the lip around the out side in order to tighten the squish up a bit.

What's the purpose of that lip?
I see it on more cylinders than not...

 

[RedFir Down]

Hey Randy as always very nice work!!
The first picture in the second set... is that a long sheet rock screw brazed to the end of that screw driver?

 

[jimmycrackcorn]

Hey Randy as always very nice work!!
The first picture in the second set... is that a long sheet rock screw brazed to the end of that screw driver?

Haha.. You like that? I noticed that a few threads ago.. Pretty good improvising to get limiter caps out easier. Guy should patent it.

 

[fastLeo151]

Randy your finished work is very nice

 

[Mastermind]

What's the purpose of that lip?
I see it on more cylinders than not...

It may be a result of the plating process, or it could serve to keep folks from over tightening the squish.

Hey Randy as always very nice work!!
The first picture in the second set... is that a long sheet rock screw brazed to the end of that screw driver?

Haha.. You like that? I noticed that a few threads ago.. Pretty good improvising to get limiter caps out easier. Guy should patent it.

Glad to see y'all paying attention.

 

[Mastermind]

Randy your finished work is very nice

I do try.