KenJax Tree
Terraphobic
Yeah there we go everyone agrees on politics:msp_thumbup:
Last edited:
Meteor Cylinder Quality
- Thread starter blsnelling
- Start date
Help Support Arborist Forum:
Yeah there we go everyone agrees on politics:msp_thumbup:
Wild Knight
ArboristSite Guru
Hi Sheila!
Loose the olives, both kinds. Add bacon. Send to me. TIA.
RiverRat2
Serio Tree Freak
I'm thinking you're right Randy,,,, I'm wondering if he know my Kiwi transplant buddy Andy (AKA: Lakeside53)
Mastermind
Work Saw Specialist
A little past history...we were all a lot better looking then.
Why is that bong sitting on that table????
Well? :msp_sneaky:
Tzed250
Addicted to ArboristSite
Because they left the Apogee III sitting on the coffee table in the living room!
No need for a bong...we had Hood River home brew. That stuff ought to come with an MSDS sheet.
Take note though on who has a coffee cup in front of him. RR2 and I had just driven practically non stop from Sacramento to Hood River. A cold beer and a warm kiss would have put me right under the table.
Last edited:
Eccentric
Mister Wizard
A little past history...we were all a lot better looking then.
Funny Bob, you look about the same to me....
November 2012 for those that are wondering....
thomas1
sodium pentothal
Who's the cutie beside the guy in the white shirt....camo hat, sunglasses?
thomas1
sodium pentothal
Update. New thread here: http://www.arboristsite.com/chainsaw/221513.htm
I finally got a chance to make this topend comparison that I promised a few weeks ago. The test mule was my Dad's early 1st month production 046. It's always been a fantastic runner. The saw is all original and stock, with the exception of a MM mod. The DP muffler cover is even original. First of all, the numbers.
OEM Mahle
Exhaust - 103°
Transfers - 117°
Intake - 73°
Squish - .032"
Compression - 172 PSI
Meteor
Exhaust - 103°
Transfers - 122°
Intake - 72°
Squish - .016"-.022" (Reverse Tapered)
Compression - 178 PSI
Both saws start, idle and rev perfectly. Matter of fact, there's almost no difference of any kind in the useablilty or power of either topend! To say I am shock, would be an understatement! This Meteor topend runs fantastic. It only has one serious problem. That is the reverse taper and resulting tight squish. At the outer edge of the piston, where it should be the tightest, it's a nice .022", right where you'd want it. On the very edge of the combustion chamber, it's only .016". It should be greater than the .022". Had this been even .001"-002" tigheter, I would not have been comfortable running it. The rest appears to be purely cosmetic. Yes, I want a nice clean port, but it's obviously not hurting performance.
Both saws were tuned in the wood where they ran best. Surprisingly, both ended up in the 14,300-14,500 range. I don't know what it is about this saw, but it's always been a runner. Perhaps the ignition timing is more advanced than what we're used to. Who knows. If I tuned either topend to 13,500, it would be crazy rich and almost impossible to clean up in the cut. Grant it, I wouldn't run them this lean for long extended work, but my effort was to tune both saws to max performance. For a work tune, they both would still be about 14,000.
Last edited:
Please make all additional comments in the new thread, http://www.arboristsite.com/chainsaw/221513.htm.
