mheim1
Addicted to ArboristSite
Anybody ever had a new piston bottom out on the crank so it won't turn over?
Just tried to replace the piston of a 361 and found this problem.
Took it of and measured the total height and it was 0.3mm taller than the original one. If the hole for the pin is a little bit low as well (hard to measure), the whole thing just sits to low.
Thinking about grinding half a mil of the bottom now.
Just tried to replace the piston of a 361 and found this problem.
Took it of and measured the total height and it was 0.3mm taller than the original one. If the hole for the pin is a little bit low as well (hard to measure), the whole thing just sits to low.
Thinking about grinding half a mil of the bottom now.