Kensie1988
Vintage Saw Maniac
I'm rebuilding a MS 361, I ordered a Tecomec Piston and cylinder kit that I will be using for the build, it is Nikasil plated and made in Italy like Meteor, and I know tecomec used to make OEM cylinders for Husky (or maybe it was just heresay).
I have already pulled the cylinder to check if it needed replace, which it did. Is there a method used to clean the Saw while rebuilding it or does it need to be broken down piece by piece and cleaned individually?
Any help would be greatly appreciated!
I have already pulled the cylinder to check if it needed replace, which it did. Is there a method used to clean the Saw while rebuilding it or does it need to be broken down piece by piece and cleaned individually?
Any help would be greatly appreciated!