hazard
ArboristSite Operative
I have talked about this jig but have never taken pictures of it. I have probably milled 30 logs with this setup. I started out with the granberg rails and there system. I did not like how limiting the jig was. The log always had to be at a certain length.
Here I am leveling the square tubing. I do not have any set distance I put the tubing down on the log. I leave enough room so I can place the 2x4's on each end. Also do not put the 2x4's down below the log of the mill will hit the log.
Here I placed the 2x4's on the tubing and clamped them in.
2x4 with 2x2 for clamping
Set the mill depth for 5 1/2". If you go less you will hit the clamps with the chain. You can still get a board out of the first cut slab. I personally cut everything at 1 1/8" so if this isn't absolutely perfect it doesn't matter.
Chris
Here I am leveling the square tubing. I do not have any set distance I put the tubing down on the log. I leave enough room so I can place the 2x4's on each end. Also do not put the 2x4's down below the log of the mill will hit the log.
Here I placed the 2x4's on the tubing and clamped them in.
2x4 with 2x2 for clamping
Set the mill depth for 5 1/2". If you go less you will hit the clamps with the chain. You can still get a board out of the first cut slab. I personally cut everything at 1 1/8" so if this isn't absolutely perfect it doesn't matter.
Chris