RES
ArboristSite Operative
I now have my rinky-dink Brazing Kit which comes with Mapp gas and about 2 minutes worth of Oxygen and a couple of differant kinds of brazing rods. Because of the limited amount of oxygen, there is no time to waste. Here what I plan to do.
o I am adding a 16mm tube to the side of a 038AV muffler at a 45 degree angle Lakeside style.
o I plan to make it fit as tightly as possible. No gaps
o I will then use my torch to heat the tube and muffler cherry red and start filling the gap with a brazing rod.
My questions are as follows:
o Which rod should I use, the bare one or the one coated with flux?
o Do I need a can of flux? If so, how do I use it?
o Any other helpful suggestions?
o I am adding a 16mm tube to the side of a 038AV muffler at a 45 degree angle Lakeside style.
o I plan to make it fit as tightly as possible. No gaps
o I will then use my torch to heat the tube and muffler cherry red and start filling the gap with a brazing rod.
My questions are as follows:
o Which rod should I use, the bare one or the one coated with flux?
o Do I need a can of flux? If so, how do I use it?
o Any other helpful suggestions?