Working on a Solo 660VA i just got and was suppose to have great compression.
Ya right. Look at this piston. I was able to clean the piston and it looks great so
now i need to find a piston to fit this thing. Finding and aftermarket or original
will be useless. So i'm asking you guys that may have some left over pistons to
measure for me so i can try to find a piston to make fit this saw. Here's what i have.
Bore 52mm
top of pin hole to edge of crown 17.40mm
bottom of skirt to edge of crown 43.20mm
wristpin 12mm
Any help is greatly appreciated
Thanks Lee
Ya right. Look at this piston. I was able to clean the piston and it looks great so
now i need to find a piston to fit this thing. Finding and aftermarket or original
will be useless. So i'm asking you guys that may have some left over pistons to
measure for me so i can try to find a piston to make fit this saw. Here's what i have.
Bore 52mm
top of pin hole to edge of crown 17.40mm
bottom of skirt to edge of crown 43.20mm
wristpin 12mm
Any help is greatly appreciated
Thanks Lee