timberwolf
Addicted to ArboristSite
Working on an alky saw, runs well on straight meth, but when I start to add some nitromethane I just can't get enough fuel in to keep the RPM down. I have drilled out the carb passages enough I would think it should flow, also tweeked the needle valve, but no luck. Even with the HS all the way out it's still half a hair lean with no more room for adjustment.
tried a couple carbs, no luck,
I added a bit of length to the pipe, but that still did not do it,
I could make a steeper coned pipe to clamp the high rpm, but I still need more fuel adjustment.
Any tips on how to get more fuel through the carb???
Do I need to retrofit a bigger carb on?
Thanks
tried a couple carbs, no luck,
I added a bit of length to the pipe, but that still did not do it,
I could make a steeper coned pipe to clamp the high rpm, but I still need more fuel adjustment.
Any tips on how to get more fuel through the carb???
Do I need to retrofit a bigger carb on?
Thanks