chainsawnut460
ArboristSite Operative
Wow guys... don't know what else to say other than eat lots of cheese boys :msp_biggrin:
should the tunepipe be stainless?
should the tunepipe be stainless?
Dammit stump where the hell is that piston I could of been back and forth to the post like 100 times by now.LOL
Alright, vid is uplaoding right now. I had one more cut left on another solid peice of oak. Not the same as in the first vid though so the times won't be an accurate display of the gains. It is a bit stronger now & pulls an easy 10,500-11,000 rpms with the 28" & 7 pin.
Here's the before video again
[video=youtube_share;-sz7DqYsr5A]http://youtu.be/-sz7DqYsr5A[/video]
Here's the done vid. Remember this ain't the same piece of wood so the times will not be accurate as far the amount of gains.
[video=youtube_share;8k8bISWTwwA]http://youtu.be/8k8bISWTwwA[/video]
10,500-11,000 THAT'S IT??????:msp_scared:
Here's the done vid. Remember this ain't the same piece of wood so the times will not be accurate as far the amount of gains.
[video=youtube_share;8k8bISWTwwA]http://youtu.be/8k8bISWTwwA[/video]
Enter your email address to join: