wodbutchr
ArboristSite Lurker
Awesome work and ingeniosity!
Like CAD should we have a JRAD (junk resurrection addiction disease)? :taped:
Like CAD should we have a JRAD (junk resurrection addiction disease)? :taped:
How's this project going?
Matt
Did you press the bearings all of the way on to the crank? Were the bearings the same thickness as what you took out?
Regards
Dan
Beside heating up the crankcase, you could have put the bearings in the freezer (-20ºC) to shrink them a bit. It could have help you press them in the crank case.
The flywheel drooped in and the clutch i pressed in, that was the easy part. Ill pull it apart again and see whats wrong....
DO NOT PULL IT BACK APART!!!
You did everything right. "tapping" the crank won't do crap. You need to give it a couple of good swats on either end with a brass hammer. It will free up. It is a chainsaw, not a rolex. Those parts are interference fit. I'm not saying to mushroom the end of the crank from beating on it, but it will take some smart, sharp blows. You'll know when it is right.
Looks like the paint bubbled on your side cover. Rather it be that then the crankcase.
worked perfect, a couple taps not even hard an its spinning good. Thanks
Enter your email address to join: