xtremez
ArboristSite Guru
Ive spent the afternoon trying to tune this saw to no avail. I can get it to run good with good throttle response but when I try to adjust the La to get the chain to stop spinning the saw just dies. I've rebuilt the carb, replaced the fuel and vent lines along with the filter, Ive replaced the intake gasket above the reed valve. I looked at the clutch clutch seeing if I had a busted spring but all looks well. I did notice when I have it running without adjusting the low idle and just letting the chain spin when I rotate the saw ( fly wheel side up ) the saw dies. Am I right to assume that I have a crank seal bad on that side or will other things cause the same symptoms. Thanks