Want to Buy Stihl 064 AV Case

[djlozar]

Looking for a full (both sides) case for a Stihl 064 AV Electronic Quickstop SN 117582878. I just bought a saw and unfortunately found a crack in the flywheel side at one of the AV mounts. Looks like the clutch side is in good shape if anyones interested.

Thanks!

 

[Definitive Dave]

the serial number wont help us figure out which style case you need, can you post a clear picture of the flywheel side that show the mounting holes for the ignition coil?
that is the easiest way to see what you need
thanks
Dave

 

[djlozar]

 

[djlozar]

Is this the wrong one? I noticed 3 mounting holes for the coil vs 2 on mine.

 

[gunnusmc03]

The eBay one accepts the dummy coil

 

[djlozar]

What about the top right corner near the coil wire holder? Ebay comes to a point but original doesnt?

 

[gunnusmc03]

That's an 064 case for sure. The point part is where the ignition wire is captured .

 

[Definitive Dave]

Gunn is steering you right for sure, the 2 hole case I see much less frequently than either of the 3 hole versions or the 4 hole case.
Dave

 

[djlozar]

So all things considered, everything should transfer over to the ebay one from mine? ie: oil pump, crank, jug, etc...what about if I choose to BB it?

 

[gunnusmc03]

that case will work. As far as the big bore don't waste your time.

 

[djlozar]

One last verification before I pull the trigger on the crankcase. The number on mine is 1122 021 0700 and the one on ebay is 1122 020 2101. The IPL I found online had the ebay number. Are the different part numbers referring to the 2 vs 3 holes for the coil mounts? Does anyone have access to x-referencing this?

You guys are helping me immensely.

 

[gunnusmc03]

The one on eBay was the latest version. The extra hole is so you can mount the universal non limited coil (highly desirable). It can also mount the older style coils.

Trust me you'll be good to go. If nothing else you can sell it for the price you're about to buy it for here.

 

[Definitive Dave]

I am pretty sure there are no bolt on big bore kits for the 064, but with a little time and expense an OEM 066 top end can give you some extra umphh, but I think the money is better spent on a well done port job for the standard excellent oem 064 top end.
Dave

 

[djlozar]

Right on. Pulling the trigger.

 

[djlozar]

Who should I contact about doing the port job? No one around here that I know.

 

[gunnusmc03]

Mastermind on here ported mine and it's a beast!

 

[djlozar]

Cant say Ive ever seen an intake like that! Looks beastly.

 

[Definitive Dave]

Brad recommended I have Mastermind port mine which I did and couldn't be happier, In fact I am sending him another one to do as well, rip roaring beast of a saw

 

[djlozar]

Good to know. I will be reaching out to Mastermind in the near future probably. Efficiency and cooler running are the top things I am interested in about porting. Power will be a nice add.