Baddboyy21
ArboristSite Operative
I have an 066 that I am working on. It ran very poorly when I got it. I checked compression, its good. Did a vacuum and pressure test. Those are both good. Checked sparked and that's good. So I figured the carb needed cleaned.
I got a K15-WJ kit. I opened up the carb and it was pretty dirty. A lot of saw dust inside it. I replaced everything except the welch plugs.
I can not get it to start now. It' seems like it may be flooding. If you take out the spark plug and pull the starter gas mist comes out the spark plug every pull.
Could it be a bad vent? There were also two different fuel pump diaphragms in the kit. I replaced it with the one that looked the same. I uploaded a pic of the exact kit I bought from dssjms. I used the one that's kind of mesh type material. The other is more like a rubber.
What type of vent system does it use? I just see a white plastic barrel with a clear plastic hose coming out. I don't see that little screw that's usually in the clear vent tube.
I got a K15-WJ kit. I opened up the carb and it was pretty dirty. A lot of saw dust inside it. I replaced everything except the welch plugs.
I can not get it to start now. It' seems like it may be flooding. If you take out the spark plug and pull the starter gas mist comes out the spark plug every pull.
Could it be a bad vent? There were also two different fuel pump diaphragms in the kit. I replaced it with the one that looked the same. I uploaded a pic of the exact kit I bought from dssjms. I used the one that's kind of mesh type material. The other is more like a rubber.
What type of vent system does it use? I just see a white plastic barrel with a clear plastic hose coming out. I don't see that little screw that's usually in the clear vent tube.