Hey guys. I have an 076 AV Super that has been a fantastic saw the last couple of years. I use it primarily for milling but it gets used for really big firewood stuff now and then. I was finishing up a job today so last night I did the usual prep, sharpened the chain, etc and it ran fine. I only ran it a few seconds just wanted to make sure it would start and it fired right up. Today I got about 2/3 through my first slab and it started acting up. It bogged down and would bog or shut off if I tried to give it throttle off idle. I was also really concerned because there was white smoke coming from the fan/electrical side. I knew the saw wasn’t running lean or hot so that it would cause that. I changed the plug and let it cool down. I finished the pass and started another one, saw was running well. But it wasn’t long before it did the same thing. Bogged down and wouldn’t come off idle. This time it was done. I can get it to idle but that’s about it. Even after letting it cool off, it runs ok for about 10 seconds and then craps out. I couldn’t finish the cut. One thing I noticed in addition to the hot white smoke coming out the fan side vent, was that the usual RPM governor seemed to be non existent. If you can coax it into running, it would spin free, higher than the usual governed 9-9400 and then it would crap out. So I think I have an electronic ignition issue. Sadly I don’t know much about this governor and electronic ignition system on this saw. What do you guys think it could be? Can I get parts? If I can’t find the exact NOS parts, what will work? I wanted to keep this thing original but I’m open to scrapping the governor system and just doing what will get me back milling asap.