Jza
ArboristSite Member
Hi guys ,bit of a background on the saw . This was a rebuild from bottom up , seals bearings , hoses , manifold .
I installed a new v3 ignition module kit with the white solenoid and orange fuel filter .
I can't get the saw to stay on choke to do the v3 reset , it dies after about 2 secs of idling . The only way I can restart the saw is wot and pull . A big cloud of smoke comes out and will only stay going if I feather the throttle .
I tryed doing a few cuts then let it idle but it was either a lean idle ( chain spinning ) or it would die.
Like I said the only way to restart would be to hold the throttle open and start it without "choke" seems like it's getting way too much fuel .
I cleaned the carburetor with just carb clean , no carb kit.
My guess would be the solenoid , but the one I put in is brand new .
This is my first mtronic build so I'm abit stumped. Any help would be appreciated!
I installed a new v3 ignition module kit with the white solenoid and orange fuel filter .
I can't get the saw to stay on choke to do the v3 reset , it dies after about 2 secs of idling . The only way I can restart the saw is wot and pull . A big cloud of smoke comes out and will only stay going if I feather the throttle .
I tryed doing a few cuts then let it idle but it was either a lean idle ( chain spinning ) or it would die.
Like I said the only way to restart would be to hold the throttle open and start it without "choke" seems like it's getting way too much fuel .
I cleaned the carburetor with just carb clean , no carb kit.
My guess would be the solenoid , but the one I put in is brand new .
This is my first mtronic build so I'm abit stumped. Any help would be appreciated!