Last edited:
Diesel JD said:.... but why not for square chisel?
TimberPig said:By the looks of it, I don't think it allows you to get the correct angle down into the cutter. It only shows graduations for up to a 10 degree tilt on the file, I'm not sure if it allows you to go further than that or not and the graduations just aren't marked. I am far from a square ground chain expert, but I believe the angle you want the file tilted at for square filing is normally steepr than that if I am not mistaken.
One of the resident square ground/filed chain experts can likely offer some more insight on this.
And then it was asked why it wouldn't do square filed.stihlatit said:TimberPig I believe in post #4 he mentions that this file setup will not do square.
Enter your email address to join: