Wolfen
ArboristSite Operative
Ok guys I have a small major problem with my chain saw not oiling and in the homeowner forum they said come here and ask, so here goes
Its a Stihl MS250 and there is no oil coming out of the port at the bar, the bar is clean the port has no crud in it the worm gear turns the pump and the little tang is there on the rod tank has been cleaned with mix gas oil recovered for use again. That's as far into it as I have been so far, looking down the oil tank with a flash light the filter looks clean and no I haven't blown it out with air yet as I have no access to a compressor today,
is the pump toast? and if it is can somebody please link me to a how to video on what I need to do to replace it?
the only reason I think it might be the pump is I work on cars and that's what usually goes bad when there's no oil
( all joking will be laughed at by me and you guys who make jokes about my total lack of chain saw knowledge )
Its a Stihl MS250 and there is no oil coming out of the port at the bar, the bar is clean the port has no crud in it the worm gear turns the pump and the little tang is there on the rod tank has been cleaned with mix gas oil recovered for use again. That's as far into it as I have been so far, looking down the oil tank with a flash light the filter looks clean and no I haven't blown it out with air yet as I have no access to a compressor today,
is the pump toast? and if it is can somebody please link me to a how to video on what I need to do to replace it?
the only reason I think it might be the pump is I work on cars and that's what usually goes bad when there's no oil
( all joking will be laughed at by me and you guys who make jokes about my total lack of chain saw knowledge )