Sure is quiet in here....do I need to start a fight?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Careful around the seals and ignition module .

Works good but you can`t let water get into the cylinder. Just bring the piston up near top dead center so it blocks the exhaust port, then give it to er. I drain the water from the muffler after and then start the saw, let it run 5 mins or so to get rid of all excess water, usually blow the airfilter out a

Good tips, thanks! Will be trying out after next use
 
I only do the exterior of saws or parts like the recoils once removed from the saw. I leave the areas like around the carb or under the E modules for cleaning with less powerful actions like a brush and solvent. Blow out everything with compressed air and the saw will live a much longer life.
 

Latest posts

Back
Top