Sure is quiet in here....do I need to start a fight?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Yup

383caf13999cebf58cbc44715abd388d.jpg


Dirty Flippycap saw.

Mighty Mouse Logging LLC
 
I grabbed my go to saw yesterday to cut the last few trees of the hurricane I am dealing with that were on a storage building at the rental. It fired right up and I looked down and started laughing...no paint on that bar. Its a cheap Oregon 24" that I have had for years. Been dressed a few times and generally taken care of but seen lots of trees. Apparently I was doing it right with out taking temperature readings and all.
 
You should have shown a side on pict, that saw is a sticky dirty mess, front on also shows a lot of sap buildup.

But the bar stayed clean after the AmourAll test so it would just slice through with no friction keeping the temps down , now we know how well that works :)
Might even have to run thinner bar oil it ran so cool .
 
Back
Top