I'll stop by next time I visit Der Slug.
Sure is quiet in here....do I need to start a fight?
- Thread starter caleath
- Start date
Help Support Arborist Forum:
Kinda out of the way
Take the long scenic route to johns!
Sent from my SM-G930V using Tapatalk
Kinda out of the way
Take the long scenic route to johns!
Sent from my SM-G930V using Tapatalk
I'll stop by Cleveland and count the dead fish and beer cans
May be there awhile..............
Go to where the ducks walk on the carp
Sent from my SM-G930V using Tapatalk
You have very low standards.......I dont care what that slug says bout you............your a stand up guy!
Your welcome here anytime
Sent from my SM-G930V using Tapatalk
Canoes are a great mode of over water transport. I have logged thousands of miles travelling solo in canoes since first stepping into one back around 1958.
Yup
Dirty Flippycap saw.
Mighty Mouse Logging LLC
Dirty Flippycap saw.
Mighty Mouse Logging LLC
My saw is dirtier than yours, it will get a cleanup this week.
I spray mine down with pam , slides through the wood faster and the pitch and gum doesn't stick to it , makes it a couple of degrees cooler as well .
Jimmy in NC
Addicted to ArboristSite
I grabbed my go to saw yesterday to cut the last few trees of the hurricane I am dealing with that were on a storage building at the rental. It fired right up and I looked down and started laughing...no paint on that bar. Its a cheap Oregon 24" that I have had for years. Been dressed a few times and generally taken care of but seen lots of trees. Apparently I was doing it right with out taking temperature readings and all.
WOW !!! Busy over here fer a change !!!
You should have shown a side on pict, that saw is a sticky dirty mess, front on also shows a lot of sap buildup.
But the bar stayed clean after the AmourAll test so it would just slice through with no friction keeping the temps down , now we know how well that works
Might even have to run thinner bar oil it ran so cool .
Here's a Mighty Mouse LLC vid of the Mighty Mouse 026 gettin it done , felling against the wind .
And real close to the wood pile!!!!
Yup , right on target lol
So, Dan, what do you do with all that spruce....furnace wood? Try to mill it into 2X's? Sell it for pulp or biomass?
