Slvrmple72
Addicted to ArboristSite
Been doin tree work and removals for awhile now and have an 088 with a 30" and 48" bar and a 460 with a 28" bar so thought I would buy a mill(s) to use with these saws. I just dropped a White Ash and left three logs from it, the main trunk about 48" diameter about 12' two primary limbs from this trunk each about 23" diameter and 12' plus a few smaller logs. I was not sure about the smaller ones I know that they tend to create warped boards. What can I do to limit splitting on the ends during the winter? I hope to start milling by late spring. Want to start out with a chainsaw mill cuz I don't know how involved I am going to get into this and I have a 12.5" Delta Planer to finish the rough cut boards. I will appreciate any input thank you very much!