What's On Your Bench? Nov 20th 2014

[JBA]

So the little saw lives on! Maybe next time ill climb with it![emoji15]

We can make that happen. Have enough extra gear that will fit you and "Big Guns" if you want to try it out. Just don't have another climbing saw. If only I knew where to get another Snellerized 201t.

 

[gregsl]

Not on my bench but the kitchen floor because the Mrs. is away.






A 260 all buttoned up after a rebuild. I even took the carry case to the rubber ducky carwash and gave it a scrub down.. And wax..[emoji4]

 

[treesmith]

Good to hear a rehab story like yours Randy

I'm building my bench at the moment, frame done, its 11' x 3' topped with one piece 19mm yellow tongue floor sheet, tomorrow it's getting a top of 2mm galv steel sheet. Then a vice, chain grinder, spinner, breaker and tool rack. My own one stop saw shop

Under my bench is a freshly stripped 346 and 372 waiting for parts, a 288 to spruce up, a 170 to upgrade to a 180, a 441 to strip the oiler, a 170 that got squashed and a 192t straight gassed that might clean up.

 

[a. palmer jr.]

A couple of 330s, an Echo and a Homelite but looks like they're gonna have to wait till it warms up, not much heat in shop..

 

[Bilge Rat LT 20]

An 024 parts saw.
It was cheap and is going to be a learning victim!

2 026 mufflers that will be modded.
Also some reading material on smaller Mig welders. Looking at a Miller 211.

 

[treesmith]

 

[Mastermind]

Very nice Andy.

 

[a. palmer jr.]

Nothing on bench, might cut a little firewood today.

 

[treesmith]

Quick check up for the week ahead then back in the sunshine, 201 isn't mine

 

[rich450es]

i tore my stihl 015av down to find out why there was no spark . the pivot for the point contact was stuck (saw has sat for 20 years in the original case) 2 drops of oil and it works like a charm now .......i will put it together in the am and hope it starts