Mastermind
Work Saw Specialist
Howdy Joe. Did you get that 390 squared away? I've been wondering.....
What's on your bench? October 9th 2013
- Thread starter Mastermind
- Start date
Help Support Arborist Forum:
Yes, cleaned the carb and replaced the throttle cable.
Mastermind
Work Saw Specialist
Sold it yet? lol
Heck no. What kinda question is that? LOL Its all cleaned up and setting in the basement. What you got for sale?
Hi Mike. How's the 288?
Mastermind
Work Saw Specialist
I've not got anything to sell right now.
I sorta figured with AS down we would run short of work, but that's not been the case at all. We aren't as far behind as we normally are, but still have lot's to do.
I sorta figured with AS down we would run short of work, but that's not been the case at all. We aren't as far behind as we normally are, but still have lot's to do.
Running great now. Loose cylinder bolts. Put about triple the lock tite I thought it needed on it this time. Never had that problem before on a saw with blue lock tite.
Glad your busy. I was wondering if this site being down was bad for business. How's big Jon?
Mastermind
Work Saw Specialist
Lucky you caught that early Mike.
Glad it was an easy fix.
Well Justin caught it. I just checked that after the fuel line and filter for the heck of it. It runs a lot better than I remember from 3 months ago. I guess the 5-6 tanks he got through it did a lot for break in. Still a pain to pull over cold. I have to stand on the foot pad and hold the handle down. I can't drop start it.
Mastermind
Work Saw Specialist
Being Big Jon.
We tore that big pole barn down next to the house. I didn't like the damn thing from the time I finished the roof. It was too big, and would have been a ***** to heat. We're gonna use the trusses and sheeting to build a 24 X 24 shop with an 8' ceiling and a wooden floor. Should make a nice shop.
I'm tired right now though.
