where do i get 372xp muffler bolts

[pa.hunter]

older model cant seem to find them anywhere ? ebay ? part store?

 

[Warped5]

www.partstree.com?

 

[Mattyo]

I think they r m5.... but once you find the right size. ...then u can buy them in bulk on ebay....and have spares

 

[farrell]

M5x25

 

[Gypo Logger]

Checking these bolts periodically is a must. When building or repairing the saw I always re tighten after running the saw when it's warm.
If the bolts have come loose often times the gasket may be shot and if not replaced the bolts will just come loose again.
John

 

[msvold]

Need to re-tighten when warm as Gypo states - plus if using an Allen wrench I also use pliers on the small end for a little more torque.

 

[pa.hunter]

M5x25

whats the length

 

[pa.hunter]

I think they r m5.... but once you find the right size. ...then u can buy them in bulk on ebay....and have spares

anyone know length if not i can pull one out of my 372 i guess thanks fellas

 

[farrell]

25mm

 

[farrell]

When it comes to metric. .......

M followed by a number is bolt diameter in millimeters

The second set of numbers is length in millimeters

 

[pioneerguy600]

25mm

So they are approximately 1" long.

 

[farrell]

So they are approximately 1" long.

Correct

 

[hamish]

The muffler bolts that mount to the cylinder (not the support) are a M6x25 SHCS (socket head cap screw). Cost about 3 cents each at a fastener store or almost $2 from Husqvarna.

 

[farrell]

Hamish is correct

I was thinking they were M6x25 but for whatever reason said they was M5x25

My apologies

 

[pa.hunter]

The muffler bolts that mount to the cylinder (not the support) are a M6x25 SHCS (socket head cap screw). Cost about 3 cents each at a fastener store or almost $2 from Husqvarna.

thanks for help fellas

 

[pa.hunter]

Hamish is correct

I was thinking they were M6x25 but for whatever reason said they was M5x25

My apologies

these are M6x25 i need long bolts?

 

[pa.hunter]

thanks for help fellas but i need long bolts/QUOTE]

 

[pa.hunter]

So they are approximately 1" long.

i need 3 " i am guessing

 

[farrell]

You need M6x25 socket head cap screws

That's 6mm in diameter and 25mm long (about 1" long)

Your local hardware store should carry them

 

[pioneerguy600]

You need M6x25 socket head cap screws

That's 6mm in diameter and 25mm long (about 1" long)

Your local hardware store should carry them

Did some of the older 372`s have long bolts that went all the way through the muffler ,from the front face all the way through to the cylinder? Many of the other Husqvarna saws had long bolts.