I tried to get a driver from a saw guy so that I could adjust the carb on my friends Pull-on. He said that the EPA sent notice that if they were caught selling them, it would be a $20,000 fine. I think that I will end up with one anyway most likely. The EPA is out of control and needs to be reined in. Those little chainsaws are going to cause global warming, you know. :msp_mad:
Where to get carburator screwdriver set for double d, splined, pacman, etc.
And memories of the girl I used to ride the school bus with came flooding back.
I just went over to site sponsor edge & engine, and the 4 pc carb adjustment link is GONE. It is a sad day when a screwdriver becomes contraband, especially when a lot of people are going to lose a chainsaw engine for lack of one.
I still have my dremel tool & cut-off wheel, though.
HF
Are you just talking about a torx driver?
Shouldn't be any problem getting them from a tool store or a electronics/computer supply store.
Can someone post a picture of adjusting tool being discussed.
Enter your email address to join: