Oklahoma,AR,MO,KS,TX GTG (Next GTG 08/27/2016 ) Fort Scott, KS

[jetmd]

Good Morning and Happy Friday!

 

[Hinerman]

Morning Chet. Everybody else must me laying on the snooze button or getting the coffee pot on. I am off today and supposed to be cutting wood at a new location with lots of hickory and oak; we will see.

 

[67L36Driver]

Morning midlanders!

Spring is over, back to the deep freeze.[emoji21]

 

[Locust Cutter]

Good morning everyone!!! Looking at making a few painful changes which should help a lot financially... We'll see.

 

[WKEND LUMBERJAK]

Same to you Chet. Looks like a beautiful day ahead.

morning Carl Brian.

 

[WKEND LUMBERJAK]

Thomas I missed you post morning to you to I think

 

[workshop]

Workshop, I think it was you who'd reflocked an air filter and discussed it couple months ago
Will you please provide the info regarding where you got the kit and the cost again?

Donjer Products. I think they are in Illinois. It was 15 or 20 years ago I bought the stuff to do a jewelry box for my wife. Maybe $15?

 

[cobey]

Good morning everyone!!! Looking at making a few painful changes which should help a lot financially... We'll see.

Oh boy, I hope all is well

 

[Hedgerow]

What did you get?

Makita 520..

 

[WKEND LUMBERJAK]

Makita 520..

That is not an ECHOOOOOOOOOOO Just saying.

 

[Hedgerow]

That is not an ECHOOOOOOOOOOO Just saying.

Nope.. But it was 50cc, runs good, cheap, and available..
He better like blue..

 

[gritz]

Well, I went to test the Solo 650 before I sent it to my aunt and it wasn't adjusting on the idle. Found it has a leaky clutch side oil seal. I guess that's what I get for letting a saw sit for two years Gonna see if the parts saw has good seals. Luckily, they aren't an oddball size seal. 15x28x5

 

[cobey]

Changing a lower control arm on
The g6 it's sucky cold .
Nothing like having to take the front
Motor mount loose to get the bolt out

 

[cobey]

Just got Done with the frosty cold control arm
And tie rod replacement

 

[Homelite410]

Morning fellas, off to the woods today! Hope to find some hardwood, this boxelder burns way too fast.

 

[WKEND LUMBERJAK]

Cut safe Mike. May your chain stay sharp, your fuel last long and you come home with all appendages still attached.

Morning all

 

[sam-tip]

Mike may your toes and fingers stay warm. 10 here. Good morning all.

 

[67L36Driver]

Morning midlanders!

16 here headed to a high of 28.[emoji21]. 43 in the garage.

 

[Hedgerow]

Hey, if everyone could keep an eye out for a set of serviceable 372/365 case halves..
I am in need of a good case.

 

[67L36Driver]

Any sand cast Poulan fans in the potbelly stove crew?



Model 31 runner.