Search results

IPL for Pioneer farmsaw 11 would be appreciated.TIA.

ray, your ipl and adjustment instructions made my day.after adjustment saw runs good with.THANKS.

Thanks CB&Mark for the info.now i have something to guide me in my search for a solution.

Good spark, starts but runs rough,trickle of fuel runs out of carb intake while running.HC11A carb removed/cleaned,replaced the diaphragm and gasket.fuel inlet control lever appears to be set correctly(level with base).No info available for this carb.Problem did not go away so i'm hoping there...

RE:Places to visit in Cape Briton. John I'm a transplant to Nova Scotia . I did the "Cabot Trail" a few years back and it was well worth the drive but i did it during the Summer and the weather was good and the scenery was beautiful. not sure about May month though especially this year with all...

Thanks for your suggestions pioneerguy.I removed the coil from a WICO assembly, did some minor changes to the laminate frame and mounting holes and i now have a good spark.Now if i could just find a solution to the fuel primer system i would be happy.

Is there a conversion coil or one from another saw that could work on the 450?

Will do Ray.

Looking for repair manual for skil 1632/partner f55 chainsaw.

Anyone have a repair manual for the skill 1632/partner f55 chainsaw they would consider sharing?TIA.

looking for the IPL for a skilsaw mod#1632c. TIA.

Any update on your research?

Looking for original style vent valve or substitute for subj. saw. The manual doesn't show such a beast and a search on the net was futile.Anyone have any info as to where i can acquire one that will do the job?

Would anyone have an IPL for a LOMBARD COMANGO CHAINSAW that they are willing to share with me?

Cantdog I do have a healthy looking spark.my problem now is when i pull the starter i get one crank revolution and everything seems to locks up( cant pull cord any further).There's plenty of cord on the starter so that should not be a problem.I'm going to replace the cord with a larger size and...

Tried all of the suggestions mentioned previously with no results,even tried the electric drill trick so that eliminates the starter cord binding.I have a large number of saws but i haven't run into this problem with any of them.Any other suggestions would be appreciated.

Thanks Farmguy and cantdog for the info,I'm a little under the weather so it will probably be a few days before i get around to working on the saw.

saw has good compression but will not start.in fact it just about pulls my arm out of socket when i try which leads me to believe that the breaker points and/or the ignition setting need to be set correctly. i have not in the past had any problems setting points but adjusting the ignition...

Pioneer 450 rings Anyone know where I can source a set of rings for this saw without breaking the bank,or if there are rings from other saws that I could use?