Search results

The stock CROSS valves on the Didier's with steel hard lines, are like most I've seen. If you change out valve to another, that either pulls or pushes the spool, will change port output. I had to use flex hoses to use the new valve (NOT CROSS) I installed, or if you reuse the solid steel lines...

Thanks, will give it a try.

Would love to know how that $75.00, 4-way wedge from TSC works out. May try it.

Please contact "wife"nhubby" on this site for copy of Didier Manual

Not a Problem, please contact member " wife'nhubby" on this site, VERY helpful! She can email you copy, send her a PM. CMK Services Report Wife'nHubby

Hello, you do NOT have to disconnect any hoses to bleed air. system will self-bleed. Remove oil tank cap and check level., should be about 1-1/2" from top when full. there is a procedure for adding hydraulic oil. basically, start machine run ram all the way out, stop engine check oil level. then...

Have Never seen a "Didier" Log splitter like that., But they made different models then most people have on this site. I have seen Didier models with main beam off to one side, and Hyd. tank in center, such as yours . But they have Didier labels on cylinder and tank. Is there a Didier Label or...

Thanks, I will check them out. I do understand ID over OD in Hoses. I also was told NAPA carries a Gate "Multi-Use" 5/8" ID hose, For Oil Use, 315 PSI, that will work. I will check BOTH Sources. Thanks,Charlie

I would have to change tank also,( not a bad idea getting bigger than then the stock 1 gal. Tank) As the barbs on the Tank are not replaceable, and 5/8" barb on pump is a Tube.

I can see getting adapter for 3/4 at the valve, but will 3/4 hose tighten enough, at the 5/8" hose barbs on the Tank and pump ? Any Brand / type hose you recommend ? Thanks....

Hello Everyone, Newbie here. Have a Didier Panther P26A Splitter with 5hp. Brigs. Need source for 5/8" Suction / Return Hose. Others on this site have changed them out to what looks like Gates (RED) Multi=purpose hose, but not sure. Hard to find as most Hydraulic shop hoses start at 3/4"...

Great Job on the Splitter !! Can you tell me What Gates Hose is on there, Multipurpose ? HARD to find 5/8" Hydraulic Suction Hose !!!

Didier Splitter I. working on a customers Didier Panther 1 Log Splitter. Had to replace OLD B&S 5hp. engine that was shot. Used Harbor Freight 6.5 hp engine. bolted up without a hitch, and only have to have the engine a little over idle to split big logs, as I had to have the Briggs screaming...