365

Phew, that was a long title. Note : 365,371,372,385,390 use the same size muffler (I am content with either OEM or non-OEM dimensions as I know they'll roughly be in the same ballpark) I'm working on a project with my son, and I am curious if anyone has the LxWxH dimensions of a muffler from...

So I've got a 365 x torq and a 266SE. I've done base gasket deletes and muffler mods on both, and opened up the transfer covers on the 365xt. I've had good luck with timing advances on other saws, simply filing off part of the flywheel key. But I can't find a lot of info on doing that with these...

Picked up this 365 Special quite a while back that had a crank seal leak and just finally got to it last night. Excited to fire it up and get it in some wood soon! If it ever dies I do plan on throwing the 372 top end on it but until then what should i do with this thing? Already has a muffler...

Hey all, been a while for me. I was given a jonsered 365. Runs great, cuts great, but it’s freakin loud! There isn’t much out there in these, anyone have any cool info on it?

Hey guys, it's been a while since I've posted here, but I'm back! I've acquired a 1997 365xp from my In-laws for $200. It's in rough shape but I thought it's the perfect saw to finally experiment on and do a full port job. I'm hoping some of you more experienced porters can chime in and give...

Just trying to thin the hurd. Saw has new oem piston and rings, carb kit. AM cover and tank. Saw is not a shelf queen but is still a good running saw. Put a tank of fuel through it after piston install. $325.00 shipped

I have a husqvarna 365, bought new this year. I have been milling slabs with it using an oregon 28" bar, trying various brand ripping chains. I have some great timber that is too big for the 28" setup (max cut width ~23"). Will my 365 be able to run a 32" bar and chain (max cut ~26-27") with...

Hello, First post here so I figure I should let you guys know what I do. I'm a faller in British Columbia, specifically logging and danger tree removal for fires around the interior. Im looking to purchase Husqvarna powerheads. I'm mainly interested in stock or modded pre-xtorq 372 or the...

Can anyone tell me the inside and outside diameter of the fuel line for a Husqvarna 365? Mine have started to split causing fuel starvation issues and rather than swap for another OEM part I am planning to buy a reel of Tygon hose as I have 4 older huskys that would benefit from a replacement...

Saw is a 2012 model. Starts, runs, oils, etc. Brake works. Some scratches and scuffs but overall a nice, clean saw. All OEM. Compression shows up just shy of 150psi on my gauge. Has a 3/8 7pin coin sprocket on it. Any questions, just ask! Local pickup, or I'll ship it anywhere in the lower 48 of...