rings

Hello, I'm pretty new on here, used to be a lurker until recently. So I just got a new MS 261 (ver 3/carb) this spring and scrolling around during that time (including that 400-500 pages oil thread, oh god) I noticed that the veterans on this site aren't big fans of this oil. "Smells bad"...

I'm just bored with saws, and really don't have time to fool with them anymore, trying to keep my wife healthy. They are all for sale individually, for $55 shipped each. They are all "open box", some I've had for awhile, some are pretty recent. They are as-is, as I'm just cleaning off the bench...

Hey arboristsite! I was wondering if any of you run a double rope bridge on a monkey beaver and how you did it, whether you just put it through the same hole on the rigging plates as the primary bridge or used a different pair. I have also thought about getting the petzl rings that open along...

By "rigging" I mean lowering stuff, whether shock/dynamic loads or simply lowering a limb that you had positive angle / tension on before cutting, not rigging for lifting things (which is where I think pulleys are useful, although it's really the sole area I think they're useful!) I always...

Hello all, I am at a complete loss- my Husqvarna 394 chainsaw will start but immediately dies. It is a 1998 model. I have already tried the following: New Gas line New Fuel filter New Fuel tank vent New tank vent filter New Gas cap Put carb kit in it Cleaned the carb Air filter is...

I bought an aftermarket rebuild kit for my Stihl 029- the old piston and cylinder head were both very scored. By jeepers one has to pull a lot of the chainsaw apart to get to the nitty-gritty! The Stihl 029 has a split crankcase which means that the piston is a fair way up the cylinder head...