CsClimbr
Ex-Climber with CAD
With what? C4? 
“I’ll take it”
“I’ll take it”
“I got a Still 44 that I blew up, you can have it”
- Thread starter CsClimbr
- Start date
Help Support Arborist Forum:
CsClimbr
Ex-Climber with CAD
I still have to lay everything out to see what im dealing with but this cylinder.. scored in this one spot. Is it junked now or possible to save??
What is that imbedded in the squish band?
CsClimbr
Ex-Climber with CAD
I noticed that after posting the pic, there was a lot of crap/dirt in there. Been tossed around in the box. Gonna go through the box more thoroughly once I’m home in a bit.
TBS
I have chainsaws and chainsaw accessories.
That cylinder looks like its toast. That gouge at the transfer port is deep and through the plating.
CsClimbr
Ex-Climber with CAD
I figured as much but was curious what would happen if say a new piston and ring were to pass over that score (after smoothing it out a bit with a dremel of course)..?
Bobby Kirbos
Scrounger of Cellulose Based BTUs
Yup, it's all junk. Send the parts to me for proper disposal.
TBS
I have chainsaws and chainsaw accessories.
Looking at where its at I'd clean it up and run it actually.
CsClimbr
Ex-Climber with CAD
crank failure that took out the top end
CsClimbr
Ex-Climber with CAD
So what am I lookin’ at here? 12mm 044? It is the wrist pin I’m supposed to be measuring?
Give it a bath
CsClimbr
Ex-Climber with CAD
I plan to.. It might be OCD but I like ‘em spotless before I can start a full build, easier to thoroughly inspect for defects that might be hiding
If only my girl was this dirty
Pull cord looks to be in excellent shape!!---David
---David
brandonstc6
Addicted to ArboristSite
You suck!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
