Want to Sell Husqvarna 575xp

[Tml061583]

Husqvarna 575 co. Currently set up as vent saw. Has rim sprocket set up. Needs muffler. Saw has no muffler on it. Starts and runs. 152 psi compression. $300. Buyer pays shipping.

 

[paco_06]

Sorry for the ignorance, but what does "vent saw" mean?

Sent from my XT1030 using Tapatalk

 

[Tml061583]

Set up with short heavy duty bar and carbide tipped chain. Used by fire departments to cut holes in roofs to vent smoke.

 

[W321shark]

Would probably be good for cutting stumps really short too. Don’t need to worry about the dirt and mud too much.

 

[paco_06]

Set up with short heavy duty bar and carbide tipped chain. Used by fire departments to cut holes in roofs to vent smoke.

OK, gotcha. Awful big saw for that, huh? I have a 570 and a 372. Won't this be in the middle of those two, or is it a size bigger than the 372?

Sent from my XT1030 using Tapatalk

 

[Tml061583]

Pretty sure the 575xp was the replacement for the 372. And yeah it's a big saw. But I guess when you have to make a hole in a steel roof deck you don't want to be short on power.

 

[Tml061583]

Simple bar swap is all it needs for regular use.

 

[DSW]

OK, gotcha. Awful big saw for that, huh?

Every one I've seen has always been 70cc or above. It's pretty common I believe.

 

[Tml061583]

Gotta have that power!

 

[W321shark]

Yeah I’d say if you are trying to save someone’s life potentially, 70cc at least.

 

[W321shark]

There’s a missed selling point “possibly, maybe, saved someone’s life”

 

[Tml061583]

Most likely did. I've got a muffler on the way as well.

 

[Deleted member 117362]

570,575,576 same series of saws and did not replace 372's. Clutch side bearing spinning in case pocket can be a problem with that series (air leak). Easy saws to work on and can stop that bearing problem with sleeve retainer. Nice saw, piston and compression looks good. GLWS!