Saw Video Thread

[Frank Rizzo]

 

[Deleted member 135597]

yup, gotta edit it together...later today or tomorrow.

for now...

awesome, i'm not interested really in the comparison vs the 461, moreso the NIB stock 462 with 1 cut on it vs the NIB ported 462 with only 2-3 cuts on it. I'm guessing a 15% gain or less. Can you confirm that the after video of the 462 only has a few cuts run time on it? thanks

 

[NSEric]

Here's the cheap Chinese saws I ported.

 

[Frank Rizzo]

 

[Mastermind Worksaws]

 

[Frank Rizzo]

 

[Mastermind Worksaws]

You don't really think that's all that impressive do you?

 

[Mastermind Worksaws]

I mean......where's the beef?

 

[Mastermind Worksaws]

Frank......your saw is knocking off those little pecker poles at about 7 seconds.

Mine is at 9 seconds in a 16" x 16" cant.

I wouldn't post that sad excuse for a port job again.

 

[Mastermind Worksaws]

How about a 441 video? I like dem.

 

[Frank Rizzo]

Frank......your saw is knocking off those little pecker poles at about 7 seconds.

Mine is at 9 seconds in a 16" x 16" cant.

I wouldn't post that sad excuse for a port job again.

Yah , 12” rounds of maple ... vs 16x16” balsa wood ..... my wood is harder ! Lol

 

[Frank Rizzo]

How about a 441 video? I like dem.

I’ll show ya a hot-woods 441c once I remember where the kill switch wire goes

 

[Mastermind Worksaws]

Yah , 12” rounds of maple ... vs 16x16” balsa wood ..... my wood is harder ! Lol

12" round.....113.04 sq in

16" square.......256 sq in.

My wood is over twice as big as yours Frankie.

 

[Mastermind Worksaws]

Oh Frankie......

From 6 years ago.

 

[Frank Rizzo]

12" round.....113.04 sq in

16" square.......256 sq in.

My wood is over twice as big as yours Frankie.

Yah , buts it’s only 1/2 as hard !

 

[fruecrue]

How’s about some MOFO 460 action.

 

[fruecrue]

Or a clamshell tearing up 32” of ash.

 

[Deleted member 135597]

How’s about some MOFO 460 action.

That saw has too much compression for tank jizzo. Compression is a rpm Killa as can be heard in your vidjo

 

[fruecrue]

That saw has too much compression for tank jizzo. Compression is a rpm Killa as can be heard in your vidjo

I believe 215 after 1/2 tank on fresh cabers. I should check again now. 4 strokes well above my comfort range.

 

[Deleted member 135597]

I believe 215 after 1/2 tank on fresh cabers. I should check again now. 4 strokes well above my comfort range.

Shhhhhhh don’t tell Frankie that!