Got a Stihl 441C bought it with a broke case on clutch side.bought a set of used cases.bought new oem bearing and seal,case gasket,spring for handle to cylinder and buffer.has new oem rings.got this far did pressure vac test had a leak threw tank vent hole.tried tightening up case bolts and one started to strip [emoji2959] ran a tap in it to try and use a little longer bolt and tap broke[emoji2959][emoji2959] so cases have to be split again.theres enough tap to grab onto to pull it out after the cases are spilt.but I'm done with it.got other stuff to do.i have everything for the saw.no plastic cracked or broke.this saw did run when I bought it.i have good flywheel side case that has the stripped hole also.cylinder is good.piston has a few little pin marks on the top.im betting from water in the gas a some point.wont hurt anything.will also need a decomp or a plug.decomp failed pressure test.$200 plus shipping.just trying to re coop what I got into it.
Sent from my Pixel 2 XL using Tapatalk
Sent from my Pixel 2 XL using Tapatalk