Martinm210
ArboristSite Operative
Thought it might be fun to put a little worklog together on my new project. I decided to finish up my 066 after I get done with this one as I didn't want to have two saws in pieces at the same time.
So, here is day one, a parts saw off ebay, turned out to be in a little worse condition than I expected. Saw was noted as "Runs, but missing side covers". I bought a good used starter cover along with the parts saw.
This is what I ended up with:
After a couple of bolts on the cover, I proceed to pull the starter slowly with an immediate sense of "Oh boy...bad crank bearings...not good".
So I tore it all down....cylinder had more scoring than I wanted too...so my plan is to rebuild bottom to top and use an 046BB piston/cylinder for the top end..
Plan to make good use of my new sand blast cabinet and arbor press..
So, here is day one, a parts saw off ebay, turned out to be in a little worse condition than I expected. Saw was noted as "Runs, but missing side covers". I bought a good used starter cover along with the parts saw.
This is what I ended up with:
After a couple of bolts on the cover, I proceed to pull the starter slowly with an immediate sense of "Oh boy...bad crank bearings...not good".
So I tore it all down....cylinder had more scoring than I wanted too...so my plan is to rebuild bottom to top and use an 046BB piston/cylinder for the top end..
Plan to make good use of my new sand blast cabinet and arbor press..