EvilRoySlade
Life's a garden, dig it
Husqvarna 353, 2004 model year. $275, we can discuss shipping.
I installed updated metal intake clamp, new Oregon rim clutch, sprocket with oiler drive gear.
Cat has been cut out, open can muffler now. I opened hole and brazed on new deflector. Gasket removed, sealed with loctite 518. Squish is at .028". Compression at 160psi. I have opened and polished exhaust port to match muffler. I cleaned up minor casting marks in lower transfers but not touched uppers.
Only real flaw is lower bucking spike bolt was broke off inside case when I aquired the saw. I've tried multiple times to remove broken piece with no luck. So now there is a 10mm long bolt instead of the stock 15-18mm or whatever it is.
Only selling because I came across a 346ne that needs a couple parts to get it going.
I installed updated metal intake clamp, new Oregon rim clutch, sprocket with oiler drive gear.
Cat has been cut out, open can muffler now. I opened hole and brazed on new deflector. Gasket removed, sealed with loctite 518. Squish is at .028". Compression at 160psi. I have opened and polished exhaust port to match muffler. I cleaned up minor casting marks in lower transfers but not touched uppers.
Only real flaw is lower bucking spike bolt was broke off inside case when I aquired the saw. I've tried multiple times to remove broken piece with no luck. So now there is a 10mm long bolt instead of the stock 15-18mm or whatever it is.
Only selling because I came across a 346ne that needs a couple parts to get it going.