quincyhoke
ArboristSite Lurker
I have been fighting a 372xp-xt rebuild getting it to run. The current symptoms are similar to an air leak where I'm having a hard time tuning the carb. I can get it to idle once warm but has poor performance in the cut. If I get the cut tuned OK it won't run at idle. The saw has no throttle response and stumbles if the idle low enough to stop chain spin. It often will die after coming of WOT.
The saw and carb are both holding pressure and vacuum. I did have a leak around the oil pump bushing but have resolved that with little improvement. Carb has a new Walbro kit in it.
Any leads are greatly appreciated, Thanks.
The saw and carb are both holding pressure and vacuum. I did have a leak around the oil pump bushing but have resolved that with little improvement. Carb has a new Walbro kit in it.
Any leads are greatly appreciated, Thanks.