Want to Buy 372xp

[Jake Surrett]

Looking for a good 372xp stock or ported

 

[quattro90]

What's your budget $?

 

[chipper1]

Good morning Jake, welcome to AS.
I sent you a PM.
Brett

 

[chipper1]

What's your budget $?

Good morning buddy, long time lol.

 

[quattro90]

Good morning buddy, long time lol.

Long time is right. hahaha

 

[cuinrearview]

PM'd, looks like you're gonna have your pick!

 

[Derf]

Are you looking for the OE (original edition), or the X-torq strato version? Or the 75cc XPW version? Do you want a half wrap or a full wrap bar? Large west coast dogs or regular small dogs? Heated handles or regular? Is this going to be a shelf queen, or do looks not matter? Do you care if it was rebuilt with aftermarket parts or does everything need to be OEM? Or are you looking for a basket case to be a builder? Are you planning to get it ported? If so by who? I guess it depends on if you’re looking for a GTG cookie cutter or a work saw. Are you going to be looking for gains in top end speed or low end torque? You aren’t planning to do any milling with that power head, are you? Or are you going to port it yourself? Maybe just start with a muffler mod... and maybe do a gasket delete too... and maybe just widen the intake... oh hell, might as well deck the cylinder, cut the squish, and advance the timing. Jesus man, give us some details!!! You can’t just register on a saw forum and say you’re looking for a 372! Now you don’t even realize how deep you just stepped in it and what a rabbit hole you’re going down! Welcome to the loony bin.

 

[chipper1]

Are you looking for the OE (original edition), or the X-torq strato version? Or the 75cc XPW version? Do you want a half wrap or a full wrap bar? Large west coast dogs or regular small dogs? Heated handles or regular? Is this going to be a shelf queen, or do looks not matter? Do you care if it was rebuilt with aftermarket parts or does everything need to be OEM? Or are you looking for a basket case to be a builder? Are you planning to get it ported? If so by who? I guess it depends on if you’re looking for a GTG cookie cutter or a work saw. Are you going to be looking for gains in top end speed or low end torque? You aren’t planning to do any milling with that power head, are you? Or are you going to port it yourself? Maybe just start with a muffler mod... and maybe do a gasket delete too... and maybe just widen the intake... oh hell, might as well deck the cylinder, cut the squish, and advance the timing. Jesus man, give us some details!!! You can’t just register on a saw forum and say you’re looking for a 372! Now you don’t even realize how deep you just stepped in it and what a rabbit hole you’re going down! Welcome to the loony bin.

Between the guys who responded I'm pretty sure we have most of those bases covered .
It is a rabbit hole.

 

[cuinrearview]

Looks like 372 is the "safe word" around here

 

[Jake Surrett]

Hey guys thanks for all the replies, looking for a 372 xtorq. $300-500 budget and really would like a oem ready to run saw. Probably do muffler mod and gasket delete later on to it but just need plain Jane ol stock one for now. Half wrap handle and small dogs, 20”-28” bar. Ain’t been a member a month and done messed up lol

 

[chipper1]

The 365 xt(it's the same as the 372xt at 71cc except the transfer covers) in this post would fit your needs, just need to get an oiler and a bar. I could probably hook you up with a bar as well.
https://www.arboristsite.com/commun...-365s-oe-and-xt-both-need-some-things.324902/