Bandit Model 90 chipper

[Kentucky 2020]

I have a Bandit model 90 chipper need to replace the hydro motor on the infeed roller. Having trouble getting it apart. Anyone ever replace one?

 

[mikewhite85]

I've owned one. The hydro motor never gave me problems. Hope you've been able to figure it out by now.

 

[Maintenance supervisor]

Have you changed the 10w30 in the hydraulic tank and clean the in tank filter?

 

[Timber1972]

You are sure it is the motor. I have a Bandit 90 and this past spring the valve went and I couldn't get the feed wheels to work. Changed it out and works like a charm again.

Sent from my SM-A205W using Tapatalk

 

[since16]

My 90xp started slowing the infeed the lever seemed fine just loosing power. And like the poster above it was the infeed handle valve its a off the shelf wood spitter valve check that first its cheap. Actually i have replaced it 2x. It seems like a hyd pump failure.