dont know if anyone had success on a simple design for using a spare bar to run a brush cutting blade...
I have a 16 inch bar that I wont use,Stihl, that I would like to add a parallel roller on the tip that would run a mini
gear box that would allow a 5-7 inch table saw blade to sit even to the ground when the bar is pointed at the ground
more or less..like a micro differential..a chain without cutters would turn it..you can picture it I'm sure....
anyone try anything like this... I find the little Stihls are nice to use cutting small brush and stuff because they are so light..
I want this device to cut sagebrush even on the ground..reasonable,yes?
I have a 16 inch bar that I wont use,Stihl, that I would like to add a parallel roller on the tip that would run a mini
gear box that would allow a 5-7 inch table saw blade to sit even to the ground when the bar is pointed at the ground
more or less..like a micro differential..a chain without cutters would turn it..you can picture it I'm sure....
anyone try anything like this... I find the little Stihls are nice to use cutting small brush and stuff because they are so light..
I want this device to cut sagebrush even on the ground..reasonable,yes?