U&A
Addicted to ArboristSite
Not sure what they are technical called. Im looking for (if even available) the little “tubes” that go behind the holes in the side of the saw to guide your screwdriver to the appropriate adjustment screw. H/L/T
Right now on my 385XP i have to get out a flashlight and look through the holes and try to line up the screwdriver to the appropriate one that I’m trying to adjust.
Just a little bit irritating when trying to adjust carb.
Is this a part i can buy? The saw was purchased second hand and the previous owner re-jet the carb for the port work and MM that was done. So I’m not sure if that part had to be removed.
Sent while firmly grasping my redline lubed RAM [emoji231]
Right now on my 385XP i have to get out a flashlight and look through the holes and try to line up the screwdriver to the appropriate one that I’m trying to adjust.
Just a little bit irritating when trying to adjust carb.
Is this a part i can buy? The saw was purchased second hand and the previous owner re-jet the carb for the port work and MM that was done. So I’m not sure if that part had to be removed.
Sent while firmly grasping my redline lubed RAM [emoji231]